Thread Rolling Machines: Model 1015HS
Model 1015HS Machine Specifications:
| Type: | Thrufeed |
| Capacity: | 1-1/8" Max / 5/8" Min |
| Rolling Pressure: | Adj. to 25,000 lbs. |
| Motors | |
| Spindle Drive: | 15HP |
| Hydraulic Capacity: | 3HP, Capacity 50 Gal |
| Coolant Capacity: | 1/4HP, 200 Gal |
| Dies | |
| Max Diameter: | 4-1/2" |
| Maximum Face Width: | 2-3/8" |
| Spindle Size: | 1-1/2" |
| Spindle Speeds: | 4-Speed Manual |
| Floor Dimensions | |
| Width: | 78" |
| Length: | 88" |
| Height: | 66" |
| Weight: | 9,500 lbs. |
| Voltage: | Wired to NMTBA standards for operation on 230 or 460 volts, 3 phase, 60 hertz. Other voltages available at additional cost. |
| Warranty: * | One year on defects in material and workmanship. This covers parts only, labor not included. For component parts not manufactured by Tesker Manufacturing Corporation, the original manufacturers' warranties will apply. |
| Specifications subject to change without notice. | |
| Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation. | |
Click here to download a pdf of the Model 1015HS specification sheet.
Click on the machine above to see a larger view. Available Options on Model 1015HS:
Center Stands (1 Set/2 Pcs)
|
Home l Why Thread Rolling l Thread Rolling Machines l Fixturing l Dies & Regrinding l Quotes & Ordering l Literature l Contact l Site Map
Copyright © 2010 Tesker Manufacturing Corporation. All rights reserved.
