Thread Rolling Machines: Model 635
Model 635 Machine Specifications:
| Type: | Thrufeed Only |
| Capacity: | 6" |
| Rolling Pressure: | Adj. to 160,000 lbs. |
| Motors | |
| Spindle Drive: | 75HP (variable) / 40HP (4-speed) |
| Hydraulic Capacity: | 10HP, Capacity 80 Gal |
| Coolant Capacity: | 1/2 HP, Capacity 120 Gal |
| Dies | |
| Max Diameter: | 10" |
| Maximum Face Width: | 7-1/2" |
| Spindle Size: | 3-1/4" |
| Spindle Speeds: | Variable or 4-speed Manual |
| Spindle RPM: | 8 - 196 (standard) |
| Floor Dimensions | |
| Width: | 87" |
| Length: | 113" |
| Height: | 52" |
| Weight: | 20,000 lbs. |
| Voltage: | Wired to NMTBA standards for operation on 230 or 460 volts, 3 phase, 60 hertz. Other voltages available at additional cost. |
| Warranty: * | One year on defects in material and workmanship. This covers parts only, labor not included. For component parts not manufactured by Tesker Manufacturing Corporation, the original manufacturers' warranties will apply. |
| Specifications subject to change without notice. | |
| Please be advised that fixturing and additional guards may be needed, depending on job being rolled. Tesker Manufacturing Corporation assumes no liability for fixturing or guards designed, manufactured or installed by anyone other than Tesker Manufacturing Corporation. | |
Click here to download a pdf of the Model 635 specification sheet.
Home l Why Thread Rolling l Thread Rolling Machines l Fixturing l Dies & Regrinding l Quotes & Ordering l Literature l Contact l Site Map
Copyright © 2010 Tesker Manufacturing Corporation. All rights reserved.
